Regarding the precautions for the use of the slitter, many people do not understand it comprehensively. Only after you have really understood this knowledge can you better use the slitter.
        1. Safe production is a necessary prerequisite, and safety matters must be paid attention to during operation.
        2. When the original paper is cut to the end, slow down properly to avoid paper break.
        3. Shut down for help if you cannot solve the problem, do not continue to run the machine under abnormal conditions.
        4. When the core of the base paper is deformed and the base paper rotates slowly, pay attention to the speed adjustment to reduce the speed as much as possible.
        5. When blowing, first stop the machine and put the paper into the tube, then restart the machine.
        6. When encountering abnormal problems and want to stop the machine, you must press the red key for emergency stop. Develop the correct emergency shutdown habit.
        7. Pull out the gas shaft separately, and support water pipes must be added on both sides. Pay attention to pull out the gas shaft safely.
        8. For problems with some base paper cores, pay attention to proper chuck clamping of the base paper core.
        9. When loading the original paper, when the original paper passes through the cutter, the paper rolls up when the paper rolls up, and then the paper must be adjusted.
        10. In the case of paper padding, keep a certain distance from the plastic shaft and the paper tray to avoid injury.
        11. When blowing, pay attention to the stability of the flash when accelerating.
        12. When adjusting the knife, first use an air gun to clean up the dust, and then perform the knife adjustment process.
        13. When using the knife slide to deal with the damaged paper of the base paper, be careful not to damage the inner paper.
        14. When using an air gun to clean the dust on the knife, first try spraying it out for a while to drain the water. If the gas from the air gun contains water, use a rag to dry the shaft before continuing.
        15. In case of category C paper, try to slow down the speed as much as possible to avoid paper breaks (1200 revolutions and 1800 revolutions are 5 minutes slower when the paper is removed and then the time difference is 7 minutes).

         All in all, the slitter must pay attention to the above content during use.