Many people are not following the rules of the high-speed slitting machine when they operate the high-speed slitting machine, so that the rules can make the high-speed slitting machine better use, so what do they need to obey?
        1. Check whether the number of joints on the cross-section of the product is the same as the number of the self-connected one. If the hot-melt adhesive applicator does not match, immediately rewind and check to prevent the inner joint from being mixed into the product.
        2. Lead all the slitted film to the winding shaft according to the operation requirements. When the hot melt adhesive machine passes through the film, no blade is allowed on the machine to prevent scratches.
        3. Stop pressing the stop button. When unwinding, do not allow your hands to touch the winding shaft to prevent your fingers from being caught.
        4. Put the paper tube that meets the specifications on the take-up shaft, cut the products that meet the requirements into the paper tubes of the upper and lower take-up shafts drawn according to the normal method, start at a low speed, and find out that the paper tube is suitable on the take-up shaft Mark the location of the installation to facilitate the next installation. When installing the paper tube, the hand must grasp the surface of the paper tube to prevent it from falling and being injured by the shaft.
        5. Start at a slow speed, observe whether the slitting film meets the quality requirements, and then slowly accelerate to start slitting. When the machine is running, it is strictly forbidden to put your hand into the machine, so as not to press the back of the hand.
        6. Open (close) the raw material bracket to a suitable width, and place the semi-finished film roll to be cut on the bracket. When loading, the hand must leave the film roll section. Two people are not allowed to operate at the same time to prevent hand Clamped by the cylinder.
        7. According to the characteristics of the semi-finished product, adjust the EPC device to ensure that the EPC photoelectricity is always on the tracking line, and pull the end of the film with the hand to start the film at a low speed to make the film go into normal.
        8. Return the photoelectricity to the center position to ensure that the slider of the unwinding table is kept in the proper position in the middle of the guide bar.
        9. Install the cutting knife holder to the appropriate position according to the requirements of the task list, fasten the lower knife, and then start at a low speed to cut the semi-finished product into the required specifications.

        After reading the above, I believe everyone already knows the rules that high-speed slitters need to follow.