Slitting machines are developing in many places, so what are the main developments of slitting machines? The development of slitting machine manufacturers is analyzed below.
        The mission power of a slitter is a comprehensive concept. During the slitting process, the stable tension system of the paper slitting machine is a major goal to ensure product quality. The magnetic powder clutch and brake are a special kind of active actuator. The paper slitting machine is filled in the mission gap or film Cut into a moment, change the excitation current can change the magnetic condition of the magnetic powder, and then adjust the transmitted torque. It can be used for stepless speed regulation from zero initial to synchronous speed, suitable for high-speed segment fine-tuning and medium and small power speed regulation system. Paper slitting machine It controls the tension between unwinding, traction, slitting, winding, etc., so that the slitting data is always in a fluctuating state during the slitting process.
        Assuming that the tension control is stable, the paper slitter can prevent the original data from deforming and drifting during the process of the machine's speed increase and decrease. The General Assembly will form the sum of laborious and non-reeling tension of the reel for the next process. Most of the previous paper cutting machines used magnetic powder clutches to control the tension. However, the speed of the magnetic powder clutch cannot be high. The paper cutting machine is liable to form high-speed conflicts of magnetic powder when it is running. The frequency conversion motor is used to control the tension system of the slitting machine. The swing roller is used for active detection. The man-machine is at a low temperature. The paper slitting machine shortens its life.

        Following the development of technology, servo drive skills, etc., it divides the raw materials into several independent units. Its mission principle is to fix the raw materials on the unloading. One end of the unloading shaft is equipped with a magnetic powder tension controller to stabilize the raw materials. The required tension is then pulled through a pair of rubber rollers to pull the raw materials. The paper slitter is cut into several pieces by the blade. It is then guided to the A and B winding shafts by the guide rollers to stop the winding products.