The automatic laminating machine is aimed at the surface lamination of printed products, such as books, posters, color box packaging, handbags, etc. In response to the continuous improvement of global environmental awareness, oily lamination will be gradually replaced by water-based lamination.
        The head of the automatic laminating machine adopts the feeder head automatic paper feeding system, the pressing steel rod adopts the hot oil circulation heating system, the compound pressure adopts the pneumatic device, the electrical system adopts PLC programming control, and the cutting system is equipped with knife and Rotary flying knife slitting device, the back of the laminating machine is equipped with an automatic paper collection system, the whole machine occupies a small area, has a high degree of automation, simple operation and high stability.
        Pre-use inspection and analysis of automatic laminating machine:
        The automatic laminating machine is best to regularly check whether there is rubber or grease on the rubber roller, and wipe the rubber traces and dust on the roller in time to ensure that the appearance of the two rollers is black, and the surface of each roller must be cleaned. After using the machine each time, it is necessary to clean the machine immediately, rinse with glue thinner and wipe the rollers with a soft towel. It is strictly forbidden to scrape the surface of the drum with a sharp tool.
        Every time the machine is turned on, the surface dust of each roller should still be wiped off. The computer bronzing machine checks whether the surface of each roller of the machine is black. When the machine shows defects or abnormal dynamics, it should analyze and find the reason and eradicate it. Wait until the machine is all normal before allowing it to continue to operate.
         The blade line of the scraper blade of the automatic laminating machine should be flat and elastic. When the appearance of detours, teeth, curling, etc. should be modified and replaced in time, use 0.15~0.20 mm manganese steel skin or the blade of the offset printing machine. Exchange it according to the original standard.
        Lubricant should be added to the transmission parts and sliding surfaces of the machine on time to ensure that the machine is in excellent lubrication conditions. Especially the large bearings of the pressure rollers are subject to high pressure and high temperature, and the lubricant is evaporated and thrown away at will. High-temperature lubricating oil, so that it can run normally under high temperature and high pressure, automatic laminating machine floor formwork support, using a steel pipe bracket composed of couplings and steel pipes, and gradually perfected as a fastener-type steel pipe bracket.