1. Paper feeding part of automatic laminating machine:
         1. Maintenance of the vacuum pump: The space between the vacuum pump and the surrounding partition wall is at least 10 cm to ensure the air flow required for cooling is unobstructed, and the surrounding temperature does not exceed 45°C. Do not allow the interface to be contaminated with oil, grease, water and other contaminants to keep the connection smooth. When the vacuum pump is running, add butter (60-100: 5g and 140: 7g) to lubricate the rolling Palin and grease nipple. After 5000 hours, only the original rolling Palin is replaced.
        2. Maintenance of the reducer of the lifting motor: after 100 hours of initial use, the oil is changed for maintenance, and thereafter, the oil is changed and maintained once at 2500 hours. The specification of the oil is 150 gear oil.
        Second, the main part of the automatic laminating machine:
        1. Maintenance of oil tank reducer: After 100 hours of initial use, change the oil for maintenance, and then change the oil to 2500/hour for maintenance once. The specification of the oil is 150 gear oil.
        2. Maintenance of ceramic anilox roller: The ceramic anilox roller used after each stop should be washed and dried in time to ensure that there is no foreign matter and glue on the surface of the roller to prevent the solidified and deposited organic matter from causing soft damage to the anilox roller. If the automatic laminating machine is not used for a long time, it should be cleaned and air-dried with moisture-proof packaging to avoid mildew spots.
        3. Maintenance of the mirror roller bearing seat: add butter once a week. (The butter used in this machine is 120℃ high temperature butter)
        4. Maintenance of laminated rubber wheel bearing seat: add butter once a week.
        5. Maintenance of high-speed machine drying wheel bearing seat: add butter once a week.
        6. Maintenance of hydraulic station: It is recommended to replace the hydraulic oil after the first 10 hours of work. The specification of the oil is Mobil 46# antifreeze hydraulic oil. Then, change the hydraulic oil at least once a year, replace the filter screen and clean the oil tank thoroughly every time the oil is changed, and check the seal ring of the oil tank. Before replacing the hydraulic oil in the automatic laminator, all the hydraulic oil in the system should be emptied. The best working temperature of hydraulic oil is 30 ℃ to 60 ℃, exceeding the above temperature will affect the service life of hydraulic oil. The hydraulic oil should be filled with unused clean hydraulic oil. It is strictly forbidden to mix and use hydraulic oils produced by different manufacturers or different types to prevent the hydraulic station from working normally due to acid slag and precipitation.
        7. Maintenance of mold temperature machines for water and oil: filters and solenoid valves should be cleaned once a month, heaters should be cleaned in March, and Teflon tubes, joints and electromagnetic contactors should be replaced once a year. , Terminal screws are tightened once every 3 months. Model of heat transfer oil: Mobil 605# heat transfer oil.
        8. Pneumatic diaphragm pump (glue pump): Every time after work, please use clean water to pump until the pump is completely clean. Remember to do this, otherwise the pump body will be damaged due to glue blockage. Our company will not be able to guarantee the situation.
        Third, the paper cutting machine part of the automatic laminating machine:
        1. Maintenance of the reducer: change the oil after 100 hours of initial use for maintenance, and then change the oil to 2500/hour for maintenance once. The specification of the oil is 150 gear oil.
        Fourth, the part of the automatic paper laminating machine receiving machine:

        1. Maintenance of the reducer: change the oil after 100 hours of initial use for maintenance, and then change the oil to 2500/hour for maintenance once. The specification of the oil is 150 gear oil.