Laminating machine manufacturers must wait for the blot to dry before laminating the film. When laminating, pay attention to the direction of the paper strands, especially thick paper, to reduce the curling of the paper due to rolling and stretching. In addition, attention should be paid to the use of hot laminator. Too high a temperature will deform the paper and film, causing the product to curl, but not too low, otherwise it will cause insufficient viscosity. The temperature of coated paper should be slightly lower than that of offset paper.
        1. Install the laminator on a special bracket and place it on a stable and firm workbench. Then make a special platform for laminating film, the height is 5 mm lower than the edge height of the laminating machine, the width is 1600 mm, and the length is more than 1 meter.
        2. Place the material to be mounted on the film or the empty cold laminator on the iron roller in front of the cold film machine. After entering the cold laminator, the coating surface is facing upward.
        3. Adjust the pressure regulating handwheel on the cold laminator, lift the upper rubber roller, and then pass the material out of the two rubber rollers by 10 cm.
        4. If laminating film is needed, the cold laminating film must be put out of the two rubber rollers of the cold laminating machine by 10 cm and placed on the consumables. The film and the consumables must be aligned on both sides.
        5. Adjust the position of the consumables on the platform so that the tightness of the two sides of the cold laminator is basically the same, then adjust the pressure hand wheel on the machine, put the top roller down, and adjust it to the empty position. The pressure on both ends must be the same.