The laminating machine is a kind of product in which a plastic film is coated with an adhesive and printed with paper as a substrate after being pressed by a rubber roller and a heating roller to form a paper-plastic product. The classification can be divided into coating laminating machine and pre-coating laminating machine. The printed product after the coating has a thin and transparent plastic film on the surface. Fastness has prolonged the service life of printed matter, so how can the amount of film be reduced when laminating? Let Xiaobian introduce it to you.
        The amount of film used by the film laminating machine is mainly related to the operation level, so it is generally recommended to:
        1. The product to be constructed must be straight. Handle uneven paper with "ruffled edge" and "tight edge" phenomena. Paper with "lotus edge" can be baked, and paper with "tight edge" can be hung to dry.
        2. Be sure to wait for the blot to dry before coating, otherwise it will cause blistering or hair pulling.
        3. Spray as little powder as possible during printing, otherwise it will cause emptying and bubbling at the powder pile. Before spraying the film, the powder should be disposed of. If the number of prints is large, the powder can be hung to remove the powder. If the number of prints is small, the powder can be wiped manually.
        4. Check the photo paper is clean before laminating, laminating the film in a clean environment.
        5. When laminating, attention should also be paid to the direction of the paper strands, especially thick paper, to reduce the curling of the paper due to rolling and stretching.
        The above is the relevant introduction to the recommendations for reducing the amount of film used when laminating the film. I hope it will help you