The manufacturers of high-speed slitting machines were informed that in addition to the latest developments in classic statistical analysis, time and frequency domain analysis, time series analysis and parameter identification models, as well as refining technology, frequency, resonance demodulation analysis and cepstrum analysis, they also analyze and process Three-dimensional holographic spectrum analysis of the vibration signal of the cutting machine, axial trajectory analysis, short-time Fourier transform based on hypothesis and non-stationary signal, wing distribution and wavelet transform.
         Through the existing microcomputer-based real-time online monitoring and fault diagnosis system and portable monitoring and analysis system, the development of virtual instrument technology, fault diagnosis equipment and instruments, and the development of virtual instrument technology are analyzed. Turn on the power and make sure the voltage, current and hydraulic system are correct and stable. Before the equipment is ready for operation, all personnel must notify the leaving equipment to ensure the personal safety of the personnel.
        When running, do not touch the running film or roll to avoid personal injury. During operation, avoid cutting and cutting the core of each drum with a knife or hard object. The first package: Before the equipment is put into use, it must be ensured that the position is adjusted and lubricated. Check whether the tool is sharp.
        After normal operation, the engine will run free of charge, check for any abnormalities, and then enter the order in advance. After work, the equipment should be adjusted in time according to the production conditions of the best working conditions to ensure medium pressure, cutting burrs, and the right side is lying flat. Ensure the smooth and precise cutting length of the cross-cutting machine on paper, increase the production management of vertical and horizontal cutting machines, continuously monitor the running status, and pay attention to the defects of wallpaper and products.

        After the work is completed, clean the equipment dust and paper scraps in time, check the grinding wheel, the water in the oil purification water block and the water storage tank, and check whether the running parts are abnormal. Then, according to the instructions, turn off the power and maintain the computer operating system.