The paper cutting machine is composed of a frame, a transmission system, a receiving and discharging machine, a tension control device, a traction member, a slitting bracket, a waste winding and a discharging device. The transmission of the paper slitter is driven by the main motor to drive the rubber roller and the receiving shaft to operate synchronously to achieve the purpose of stretching and discharging the finished product. Let's take a closer look at:
        1. Receiving mechanism and tensioning device: The receiving mechanism of paper slitter is mainly composed of chain, synchronous wheel, magnetic powder clutch and air expansion shaft. As long as adjustments are made, the two reels are controlled by one motor. The current of the magnetic powder clutch can change the tension of the receiving shaft.
        2. Traction member: The traction member of the paper slitter is mainly composed of a pair of traction rubber rollers and a plurality of hard alumina rollers, which are used to take out the raw materials of the finished product. Power is obtained from the motor through V. The belt is transferred to the active traction roller for operation.
        3. Slitting knife holder: The slitting knife holder of paper slitting machine has circular knife slitting and straight knife slitting. The operating handle can make the circular knife move slightly axially, and the circular blade and cushion can be adjusted by the plane cam. Groove shear gap.
        4. Rewinding and discharging of waste: use the wind of the blower to discharge the waste through the wind pipe.
        5. Discharge mechanism and automatic rectification: The discharge mechanism is mainly composed of discharge shaft, support block, cylinder, base, left and right moving seats, etc., and is composed of automatic correction device: photoelectric opening, correction guide roller, left and right bracket, correction moving plate and ball . Nuts and screws, synchronous motors and left and right limit switches.
        6. Paper slitter frame and transmission system: The paper slitter frame is composed of left and right wall plates, supporting blocks and unloading mechanism. The transmission system is mainly used for pulling raw materials and winding finished products. It is driven by the variable frequency stepless speed regulation motor through the motor V belt to pull the rubber roller. The main traction rubber roller and the driven traction rubber roller are in close contact with each other. The traction material is driven, and the lower circular blade shaft is synchronously operated by the active traction roller to achieve better cutting requirements. The lower circular cutter shaft drives winding A and winding B to perform synchronous operation, so as to achieve the purpose of receiving material.

        The paper slitter divides the raw material into several independent units. The working principle is to fix the raw material at the end of the discharge shaft, and install a magnetic powder tension controller to make the required tension of the raw material constant, and then pass through a pair of rubber rollers. Pull the raw materials and cut them into several pieces with a blade. Then, the guide roller is guided to the A and B winding reels to wind the finished product.