The application of the high-speed slitting machine in the paper industry is very extensive, but in the process of use, there will always be some problems. Let's take a look at the failures encountered by the high-speed slitting machine.
        1. Insufficient winding tension-treatment method: when the voltage of the upper and lower tension controllers controlling the magnetic powder clutch is adjusted to a high level, the winding tension is still insufficient, the winding film material is loose, and the winding shaft can be grasped by hand to make it Stop turning.
        It means that the output torque of the magnetic powder clutch is not enough, and the magnetic powder in it is reduced or failed due to the long time. At this time, the magnetic powder clutch should be opened, and a new amount of magnetic powder should be added to it to continue normal operation.
        2. The photoelectric tracking is inaccurate during slitting-processing methods:
        (1) The photoelectric eye adjustment method and working state are not selected correctly, and should be readjusted according to the instructions;
        (2) The color difference between the traced line or edge and the surrounding film material is not obvious, and the contrast of color difference should be increased.

        After reading the above, I believe everyone already knows the failure of the high-speed cutting opportunity.