When using the automatic slitting machine, you should pay attention to many issues, so that safety can be guaranteed, the following slitting machine manufacturers share some suggestions for use.
        Before the automatic cutting machine is put into operation, we must first check whether each working position is adjusted properly. The parts to be lubricated should be filled with lubricating grease in advance to check whether the tool is sharp. Before the equipment is ready for operation, all personnel must notify leaving the equipment to ensure personal safety before starting operation; avoid touching the film roll or roller core with hands, so as to avoid the risk of personal injury caused by the hands involved; avoid scratching with a knife or hard object 3. Cut the roller core.
        When using the automatic cutting machine, we must pay attention to ensure that the voltage, current and hydraulic pressure are correct and stable before starting. After everything is normal, you can run it empty, check for any abnormalities, and enter the processing order into the computer order inspection in advance; after the equipment is put into operation, the best working state of the equipment should be adjusted in time according to the production situation to ensure the indentation of the slitter Moderate, slitting without burrs, and proper trimming position on both sides. Ensure that the cross-cutting machine feeds and discharges smoothly, and the cutting length is accurate. For the cross-cutting machine that is connected to production management, it also needs to monitor its operation status from time to time to prevent paper jams and defective products.

        After the work is completed, clean up the dust and paper dust on the equipment in time, check the cutters and grinding wheels, drain the water in the oil water leveler and the gas storage tank, and check the operating parts for abnormalities. Then, cut off the power according to the operation requirements of the manual, and maintain the computer operating system. In addition, if there is a problem with the automatic slitting machine, you must find a professional to repair it. Before the repair, you must turn off the electric switch to avoid potential safety hazards.