If the blade setting of the paper slitter is not good, then the whole slitting process is prone to problems, then the slitting machine manufacturer will introduce how to set the blade for everyone.
        1. The cutting edge of the blade should be kept sharp, and the cutting edge should be blunt or damaged. It should be sharpened or replaced in time. When multi-person operation is carried out, there should be a special person to command, and coordination should be coordinated. It is forbidden to cut two materials of different specifications at the same time on the round cutting blade, and overlapping cuts are not allowed.
        2. The workpiece cut by the blade of the slitter must be placed steadily. Do not stack it too high or stack it in the aisle. Remaining materials and waste materials should be cleaned up in time to keep the site tidy.
        3. When cutting into the material, it is forbidden to use the handle to promote the operation under the pressure plate. When cutting the short material, use another iron plate to hold it. When cutting the material, keep your fingers at least 200 mm away from the knife edge. After using the lever to match the wire, the lever should be withdrawn immediately before cutting. If the iron plate moves, use a wooden pillow to prevent it from popping out and hurting people after the pressure foot comes down.

        After reading the above, I believe everyone already knows the blade setting problem of the paper slitter.