During the application of the paper slitter, some small faults are prone to occur. Let's analyze it together.
         Question 1: Burrs on the paper trays at both ends.
         Analysis: Generally, the width of the original paper will be larger than the standard size, but in some special cases, it will jump out of this range, so burrs will appear, the solution is also very easy, and it will run after a while.
        Question 2: The core of the original paper is not deformed, but the rotation is very shaky
        Analysis: The general reason is that the chuck of the original paper is forcibly clamped on one side, which will cause an imbalance on both sides. The solution is to pay attention to the balance of the paper core on both sides when the chuck is added.
        Question 3: The paper tray on the right side protrudes when slitting
        Analysis: There are two reasons. The first is that the strips at the edges may not be tightened. The solution is to properly pad the strips when cutting the strips. Another possibility is that the inner diameter of the paper core is too large, which can not be locked after the pneumatic shaft expands. The solution is to check the inner diameter of the paper core.

        The above are the three minor faults and solutions that are prone to occur during the operation of the paper slitter.