What is the development and working conditions of the paper slitter? Let's take a look below.
        The mission power of the slitter is a comprehensive concept. In the slitting process, the stable tension system of the paper slitter is a main goal to ensure product quality. The magnetic powder clutch and brake are a special type of active actuator. The paper slitter is filled with mission gaps or films Cut into moments, changing the excitation current can change the magnetic state of the magnetic powder, and then adjust the transmitted torque. It can be used for stepless speed regulation from zero preliminary to synchronous speed. It is suitable for high-speed section fine-tuning and medium and small power speed regulation system. The paper slitter controls the tension between unwinding, pulling, slitting, and rewinding, so that the slitting data is always in a fluctuating state during the slitting process.
        Assuming that the tension control is stable, the paper slitter can prevent the original material from being deformed and drifting during the process of speeding up and speeding down. The pass will form the sum of the trouble of the next process and the tension of the unwinding shaft. Paper slitters used to use magnetic powder clutches to control tension. However, the speed of magnetic powder clutches cannot be high. When paper slitters are running, high-speed conflicts of magnetic particles are easily formed. Frequency conversion motor is used to control the tension system of the slitting machine. The swing roller is used for active detection. The man-machine is used for low temperature. The paper slitting machine shortens its life. When severe, it will be stuck and the machine will be blocked.
        With the development of technology and the composition of servo drive technology. It is to divide the raw material into several independent units. Its mission principle is to fix the raw material on the discharge. One end of the discharge shaft is equipped with a magnetic powder tension controller to stabilize the raw material. The required tension is passed through a pair of rubber rollers to pull the raw materials. The paper slitter is cut into several pieces by the blade. Then it is guided to the A and B winding shafts by each guide roller to stop the winding product.

        After reading the above, I believe everyone already knows the development of the paper slitter.