In the process of using the automatic slitting machine, bursting tends to occur, so how to solve this problem?
        If you want to solve the bursting phenomenon of the slitter, you must know the process of bursting. Bursting is a bulging phenomenon caused by the accumulation of tolerances due to the large thickness tolerance of the film when slitting the film.
        When slitting a composite film with ribs on only two sides, when the paper tube machine factory received about 300 meters, before the ribs did not show up, the rolls on the two sides of the reel were swapped. When it reaches about seven hundred meters, you can adjust each other again, so that the finished product rolls will not be burst. When receiving multiple kilometer rolls with bursting ribs on multiple screens, when winding around 300 meters, replace a roll of film with no problem before the bursting ribs do not show up and continue to wind up. In this way, the burst ribs cannot be expressed, and the film will not be stretched and deformed, thereby improving the paper tube mechanical yield.
        Sprinkle a small amount of sanitary-grade smooth powder during the winding of the slitting machine, which can also alleviate the bursting phenomenon.

        After reading the above content, I believe that everyone already knows the solution to the bursting phenomenon of the automatic slitting machine.