The application of slitting machines in our country is already very extensive. This product is designed in many fields, and some problems are easy to occur in use. The following slitter manufacturers share two common problems.
       Why is the paper tray cut to the right protruding for a while?
       1. When starting to run, the edge of the paper is not tight, you can properly pad the paper when the machine starts cutting to avoid
        2. The inner diameter of the paper core added to the paper core is too large, so that the paper core cannot be locked after the expansion of the air shaft so that the paper core slides when the rotation rotates to cause an offset. The solution is to check the inner diameter of the paper core when the paper core is placed on the inlet shaft. size.
        Why does the base paper core shake even when it is not deformed?
        Generally speaking, the slitting machine will not shake too much when the core of the base paper is not deformed, but if the chuck is forced to be clamped when loading the base paper, it will cause an imbalance on both sides. In this case, the operation control It will have a great impact, so when adding the paper chuck, pay attention to the balance of the paper core on both sides. Why do the paper trays at both ends sometimes have burrs?
        The width of the base paper will generally be 3-5mm larger than the size marked on it. Under special conditions, it will jump out of this range. If the size of the base paper is 1185mm, we will adjust the knife to 1190. In the case of the base paper may be greater than 1190, the side paper tray There will be glitches. In this case, you can first stop and loosen the knife for a while, wait for a while, and tighten the knife on both sides.

        I believe everyone knows these two common problems.