The operation of the slitting machine is not so simple. In order to make the slitting machine better used, we must understand the operation steps of the slitting machine. The following is the operation steps of the slitting machine manufacturers.
        When you turn on the power, you must first check whether the static elimination mode is turned on. This is to prevent the machine from malfunctioning and causing unnecessary losses during operation. Next, turn on the air pressure switch of the slitter device and adjust it to 0.5 to 0.6. The adjustment of air pressure is critical because it affects the stability of the operation. After the adjustment is completed, use three to six cones to place the mother roll into the roll section. After the mother roll is placed in the roll section, the machine should be debugged, and then the roll film should be clamped so that it can rotate uniformly or quickly. Then, press the height adjustment button again to confirm the safety. The next step is to install the blade. First, check the blade edge of the blade to see if there is any damage, and then select an appropriate slitting method to adjust the placement position of the blade. After this step is completed, you can debug the paper core module.
        The parts and components of each part of the slitting machine are very important. A little inconsistency may cause the cut-out paper to be not flat and the cuts to be kept concise. One-time slitting, so the quality of slitting equipment is very critical.

        After reading the above content, I believe that everyone already knows the operation steps of the slitting machine.