There are burrs on the paper tray of the paper slitter, so how to avoid this situation? In addition, the paper tray will appear prominent, so how to avoid it?
         The width of the base paper is generally 3-5mm larger than the size marked above. Under special conditions, it will jump out of this range. If the base paper size is 1185mm, we adjust the knife to 1190. In the case of the base paper part may be larger than 1190, the paper tray at the edge There will be glitches. In this case, you can stop and loosen the knives and wait for a while, then tighten the knives.
         Why does the paper tray on the right side of the paper slitter protrude after slitting for a while? At the beginning of operation, the paper strips at the edges are not tightened. You can avoid this by inserting the paper strips properly when the machine starts cutting.

        The inner diameter of the paper core added with the paper core is too large, so that the paper core cannot be locked after the air shaft expands, and the paper core slides during rotation to cause displacement. The solution is to check the inner diameter of the paper core when the paper core is inserted into the shaft.