Regarding the paper bag machine, many friends have raised various problems in the process of using it. So, to help you solve these problems, today I will focus on some common paper bag machine problems and solutions. Hope it could help everyone.
        1. Q: The bag wrinkles when passing the middle rubber roller?
        Answer: 1. Back seal cooling effect is not good; 2. 2. The intermediate rubber roller pressure is uneven; Excessive pressure; 4. 4. Excessive dust on the middle rubber roller; Back seal temperature is too high; 6. 6. The air pressure of the floating roller of the used bag making machine is too high; The installation of the diaphragm is inclined;
       2. Q: At the front cutter rubber roller, the film goes in one direction?
       Answer: 1. 1. The pressure of the rubber roller is uneven, and the advancing film goes in the direction of high pressure; 2. The photo frame is tilted, and it should be kept level with the front rubber roller; 3. The punching knife is not installed properly, and it is easy to tilt up; 4. Uneven thickness on both sides of the film; 5. The pressure of the horizontal sealing knife is not uniform, and one side is going to the other side. 7. The diaphragm is inclined; 7. The middle rubber roller is not parallel;
        3. Q: Is there no film on the small membrane board?
        Answer: 1. The installation of the white roller cannot exceed the template, preferably 8mm narrower; 2. 2. The pressure on the hammer is small; 3. The upper film hammer is tilted outward and inward; Membrane plate inclined; 5. 6. The pressure at the rubber roller cannot be too large; 6. Unloading tension is too large to be easy to film; 7. The tension of the film roll is not good;
        4. Q: How long is the bag out?

        Answer: 1. There is more dust on the photoelectric head; 2. 2. The photoelectric sensitivity is not enough; 3. Tracking power is not obvious; 4. Excessive sealing pressure; 5. There are dirty things on the glue stick; 6. 6. The air pressure of the floating roller of the used draw frame is too high; 7. Unloading tension is too large; 8. 8. The longitudinal sealing knife is too tightly rolled; The temperature of the horizontal sealing knife is too high. Low air pressure at the front and middle rubber rollers; 11. Feeding and pressing are not synchronized; 12． The distance between the photoelectric and the cutter is too long; 13． Excessive difference between waiting time and heat sealing time;