The operation of the pipe cutter requires two steps
I. Inspection before the pipe cutting machine is turned on
1. Check whether the saw blade is intact and need to be replaced in time when there is a shortage or crack.
2. According to the specifications of the high-pressure hose, replace the corresponding positioning pins and guide sleeves.
Operation steps of pipe cutting machine
1. Turn on the power and start the motor first.
2. Next, insert the cut high-pressure hose into the changed guide sleeve, and pull the knife-shaped handle to drive the hose into the saw blade. Then the hose is cut off. When the slide is reset, it is pulled back to its original position by two tension springs.
3. Then insert the inner hole of the cut rubber tube into the positioning pin shaft. When the saw blade rotates, make a slit at the place where the rubber is to be peeled to ensure that the rubber tube has a good rubber breaking effect.

4. At the end of the work, the power needs to be switched off.