As for the paper cutter equipment, we may sometimes find that the paper cut by it is slightly inclined, and the product does not meet its production standards. So what are the reasons for this?
        After our careful research, we found that in the paper cutter, the viscosity of the adhesive layer is relatively strong, so the resistance value to be overcome during the cutting process of the lower knife is relatively large, and it has just been cut. At the moment of cutting, the paper presser will rise slightly, which will cause its cutting to tilt. We continue to analyze this phenomenon. After a series of tests on the operating pressure of the paper press related to the solenoid valve, the purity of the circulating lubricant, and the hydraulic system, we found that the operating pressure of the paper press cylinder and the skills requirements of the machine will be between There is a certain gap; afterwards, we can take apart and check the paper pressure cylinder, and found that the compression spring in the oil cylinder has been broken into two sections, and its elastic pressure value will also decrease accordingly. After replacement, the operating pressure value of its pressure cylinder will return to its normal state, and the paper cut by the cutting machine will no longer tilt.

        In fact, after using the tension spring in the paper cutter for a period of time, it will become tired and cracked, and the pressure value in the pressure cylinder will be reduced accordingly. It does not have any effect; and only when the viscosity of the sticker is relatively large at the same time, due to the increase of its resistance value, the corresponding cutting offset phenomenon will occur.