In the program-controlled paper cutter, every time we install a new blade or sharpen the old blade, we need to manually adjust the height of its knife to adjust the cutting amount of its blade, which can effectively avoid Accidents such as cutting too deep due to large blade heights occur. First of all, we must pay attention to making sure that its motor is turned off when adjusting its blades, as long as it is completely stopped . So what are the steps in the adjustment of the program-controlled paper cutter, let's briefly introduce it to everyone below.
        First, we need to make sure that the cutter is in the tool change state, that is, stop the operation of its main motor, press the stop button of its main motor, and ensure that it is in a stationary state before changing its tool selection switch in the middle. Knife position.
        Next, we need to determine the cutting depth of the blade. At this time, we can use a socket wrench to rotate the nut on the end face of the pulley so that the knife can move to a certain lowest point. At the same time, we must observe the depth of its blade. Whether it is reasonable or not is generally a depth of 0.5 to 1 mm.

        Regarding the blade adjustment process, if only one end of the blade and the blade can be contacted, we can solve it by adjusting the eccentric shaft on the rear of the main frame; when the blade cannot cut the paper normally due to wear, we can Move the blade down in the direction of its long hole until it can completely cut the paper.