1. When the program-controlled paper cutter is turned on, mechanical inspection should be carried out and safety inspections done, such as daily cleaning and refueling of oil holes.
2. After doing the above measures, after checking the photoelectric measures of the program-controlled paper cutter, multiple operations should be performed to observe whether it is normal. If any abnormality is found, it should be eliminated immediately.
3. When operating the program-controlled paper cutter, you should work with all your heart and mind, and do not do anything unrelated to your job, to avoid distraction and increase the risk factor. Of course, two people are also prohibited from operating the program-controlled paper cutter at the same time.
4. During the operation of the program-controlled paper cutter, do not put your hand into the machine. If you find that the fault cannot be corrected by hand, you must stop the machine first.
5. Do not perform ultra-high operations when cutting paper with a program-controlled paper cutter to avoid accidents or operating loads.
6. When replacing the cutter of the program-controlled paper cutter, the machine must first be stopped before it can be replaced.

7. Regarding the maintenance of the program-controlled paper cutter, it is enough to refuel and clean up the oil holes.