The mission power of the slitter is a comprehensive concept. In the slitting process, the stable tension system of the paper slitter is a main target to ensure product quality. The magnetic powder clutch and brake are a special active actuator. The paper slitter is filled in the mission gap or film. By cutting the moment, changing the excitation current can change the magnetic state of the magnetic powder, and then adjust the transmitted torque. It can be used for stepless speed regulation from zero initial to synchronous speed. It is suitable for high speed section fine adjustment and medium and small power speed regulation system. The paper slitting machine controls the tension between the unwinding, pulling, slitting, winding, etc., so that the slitting data is always in a fluctuating state during the slitting process.
        Assuming that the tension control is stable, the paper slitting machine can prevent the original data from being deformed and drifted during the process of speeding up and slowing down the machine. The meeting will create the sum of the troubles of the next process and the tension of the reel. Most of the previous slitting machines of paper slitting machine use magnetic powder clutch to control the tension, but the speed of the magnetic powder clutch can not be high. The paper slitting machine is easy to form a high-speed conflict of magnetic powder during operation, and the paper slitting machine is mostly used for the sachet. The variable frequency motor controls the tension system of the slitting machine, and uses the pendulum roller to actively detect, and the man-machine is used for low temperature. The paper slitting machine shortens its life, and it will be stuck when it is severe, and the machine operation is blocked.

        Following the development of technology, servo drive skills, etc. It divides the raw materials into several independent units. The mission principle is to fix the raw materials on the discharge, and the magnetic powder tension controller is installed at one end of the discharge shaft to stabilize the raw materials. The required tension is then pulled through a pair of rubber rollers to cut the raw materials, and the paper slitting machine is cut into several strips by the blade. Then, the guide rollers are guided to the A and B winding reels to stop the winding products.