Laminator manufacturers must wait for the print to dry before laminating. When laminating, pay attention to the direction of the paper strands, especially thick paper, to reduce the curling of the paper due to rolling and stretching. In addition, pay attention to the problem when using the heat laminator. Too high temperature will deform the paper and film and cause the product to curl, but not too low, otherwise it will cause insufficient viscosity. The temperature of coated paper should be slightly lower than that of offset paper.
Multifunctional laminating machine, automatic and multifunctional integrated cold and hot laminating equipment, equipped with improved traditional laminating technology, reducing costs, improving laminating quality and saving environmental protection. High transparency, good color reproduction, not affected by climate and temperature changes, completely eliminating wrinkles, bubbles, shedding and other phenomena.
1. Install the laminating machine on a special support and place it on a stable and firm workbench. Then make a special platform for film laminating, the height is 5 mm lower than the edge of the film laminating machine, the width is 1600 mm, and the length is more than 1 meter.
2. Put the material that needs to be laminating or air-loaded cold laminator on the iron roller in front of the cold laminator, and the coating side will face up after entering the cold laminator.
3. Adjust the pressure regulating hand wheel on the cold laminator, raise the rubber roller, and then pass the material 10 cm out of the two rubber rollers.
4. If you need to mount the film, you need to pass the cold laminating film 10 cm out of the two rubber rollers of the cold laminating machine and place it on top of the consumable. The two sides of the film and the consumable must be aligned.

5. Adjust the position of the consumables on the platform so that the tightness of the two ends on the cold laminator is basically the same, then adjust the pressure regulating hand wheel on the machine, and lower the glue roller to the idle position. The pressure at both ends must be the same.