Structure and configuration of hot laminating machine:
1. Manual paper feed.
2. The baffle of the paper feeding table can be adjusted according to the paper width.
3. The photoelectric paper stacking positioner can automatically control the length of the paper between the paper (optional).
4. Heating method: electric heating tube, the temperature can be adjusted according to the requirements of the laminating film.
5. Pressurization method: Air pressure method can avoid site pollution caused by traditional hydraulic method. In addition, the pressure can be adjusted according to the requirements of the lamination.
6. Punching hob can roll out a row of small holes on the edge of the film to achieve automatic slitting smoothly.
7. Anti-curve device: The paper after lamination is shaped by the anti-curve device. After slitting, the paper is no longer curled.
8. The film slitter can cut wide and long film rolls (relative to paper specifications). After cutting, the excess film remains on the film release shaft.
Saving film when operating the laminating machine can greatly save costs. This is also the most basic operating specification of the laminating machine. Here are some suggestions on how to save film:
When laminating, attention should be paid to the texture direction of the film, especially the thick film, to reduce the phenomenon that the film is curled due to rolling and stretching.

Laminating machine should pay attention to control the speed, control the speed according to the actual experience and material changes, try to maintain a uniform speed.