Inspection work before the automatic laminating machine starts:
 1. Detection before starting the automatic laminator ⑴ Confirm whether the machine is in a safe state.
 2. Film transport adjustment to make the film tension even to adapt to the film transport tension.
 3. Check whether the gap between the glue roller and the glue is parallel.
 4. Check the temperature of the heating roller to avoid inaccurate thermometer.
 5. The pressure that the pressure gauge must reach, otherwise the pressure will affect the product.
 6. Clean the sundries on the rubber roller, so as not to cause waste in the finished product.
 After completing the preparation work, close the main power switch, turn on the heating cylinder and the motor, then turn on the oil pump, adjust the flow rate of the laminating glue, and adjust the parallelism between the rollers. Adjust the measuring position of the paper on the feeding table, apply the film-coated glue, and turn on the drying tunnel for heating. After testing several sheets of film, adjust the heating temperature, pressure and air intake of the heating roller again until the effect is good, and then start normal work.