The amount of film used by the hot laminator during lamination is mainly related to the operation level. It is recommended to:
        1. The product to be constructed must be straight. Handle uneven paper with "ruffled edge" and "tight edge" phenomena. Paper with "lotus edge" can be baked, and paper with "tight edge" can be hung to dry.
        2. Be sure to wait for the blot to dry before coating, otherwise it will cause blistering or hair pulling.
        3. Spray as little powder as possible during printing, otherwise it will cause emptying and bubbling at the powder pile. Before spraying the film, the powder should be disposed of. If the number of prints is large, the powder can be hung to remove the powder. If the number of prints is small, the powder can be wiped manually.
        4. Pay attention to the direction of the paper strands, especially thick paper, to reduce the curling of the paper due to rolling and stretching.
        There is also: the temperature is generally controlled to 40 ~ 60 ℃. Too high a temperature will deform the paper and film, causing the product to curl, but not too low, otherwise it will cause insufficient viscosity. The temperature of coated paper should be slightly lower than that of offset paper.