1. The sensing element of the temperature controller uses a thermocouple to detect the temperature. Due to the greater influence of the receiving and installation location, the surrounding air temperature and the internal wind flow, the accuracy of the temperature measurement has a large error, as indicated on the temperature table The temperature is a relative temperature, and the user should select the temperature based on the actual processing experience relative to the indicated value of the reference temperature table.
2. Glue, thinner and cleaning agent are flammable, pay attention to fire hazard near the machine.
3. When the machine is running, it is forbidden to put your fingers into the two rollers to avoid sticking hands; the temperature of the pressing roller of the machine is high, and you must not touch it with your hands to prevent burns. Turn on the machine at low speed when scrubbing the machine. It should be scrubbed in the correct position to prevent the cloth in the hands of the tractor from being crushed in the two rollers.
4. Be sure to unload the hydraulic system during shutdown to separate the pressure roller from the rubber roller and loosen the preload roller of the scraper load to avoid deformation and damage of the two rollers under long-term pressure.
5. The main power switch of the machine should be turned off during maintenance and inspection of the machine. The electrical system of the machine should maintain good insulation to prevent moisture. When you stop using the machine, you should cut off the power to prevent accidents.
6. It is strictly forbidden to place any tools, devices, debris on the machine, the working air gap of the rubber roller and the rubber roller is extremely small, and any hard objects will be pressed on the rubber roller when they are pressed into the surface of the rubber roller. Pit depressions or cracks. The lighter ones require a longer period of natural elastic recovery, while the heavy ones directly scrap the rubber rollers.

7. The newly installed machine should strengthen the lubrication of the machine, and be careful not to use the machine quickly during the running-in period of the machine transmission.