Precautions for use of roll-to-roll laminator
        1. Install the cold laminator on a special support and place it on a stable and firm workbench. Then make a special platform for laminating film, the height is 5 mm lower than the edge height of the laminating machine, the width is 1600 mm, and the length is more than 1 meter.
         2. Place the material to be mounted on the film or the empty cold laminator on the iron roller in front of the cold film machine. After entering the cold laminator, the coating surface is facing upward.
        3. Adjust the pressure regulating handwheel on the cold laminator, lift the upper rubber roller, and then pass the material out of the two rubber rollers by 10 cm.
        4. If laminating film is needed, the cold laminating film must be put out of the two rubber rollers of the cold laminating machine by 10 cm and placed on the consumables. The film and the consumables must be aligned on both sides.
        5. Adjust the position of the consumables on the platform so that the tightness of the two sides of the cold laminator is basically the same, then adjust the pressure hand wheel on the machine, put the top roller down, and adjust it to the empty position. The pressure on both ends must be the same.
        6. If the laminating machine is empty, you can shake the handwheel to move the consumables forward. It must be even when shaking, moving at the same speed, not fast or slow. If there is no wrinkle after 5 meters, it means there is no quality problem of consumables.

        7. If laminating film is required, first fold the cold laminating film release paper inward to expose the glue surface on the PVC film, then shake the handwheel in the opposite direction, first stick the adhesive surface to the consumables, and then apply the cold laminating film Turn the whole back of the rubber roller, and slowly release the cold laminating film from the fold. At this time, turn the rubber roller to rotate it forward. With the rotation of the rubber roller, slowly remove the release paper and keep the tightness of both sides consistent. With a certain intensity until the end of cold mounting.