Full-automatic laminating machine is to apply plastic film with adhesive and combine it with the printed matter using paper as the substrate, pressurized by the rubber roller and heating roller, and form a paper-plastic product, which should be very extensive. , The automatic laminating machine has very high requirements on accuracy at work, especially the surface accuracy and shopping degree of each roller. Once the slightest streaks, cracks, scratches, obscuration, or a slight roundabout deformation. All will affect the processing quality of the product, even not working properly. Therefore, it is very important to protect the fully automatic laminating machine carefully and carefully.
       Daily maintenance matters of automatic laminating machine:
       1. Always check the oil pipes, valves and cylinder plugs of the hydraulic system for oil leakage. When oil leakage is found, the sealing ring should be replaced in time, and the appropriate amount of hydraulic oil should be filled into the hydraulic cylinder in time;
        2. Fully automatic laminating machine should always check whether there is rubber or grease on the rubber roller, and wipe the rubber traces and dust on the roller in time. Keep the two rolled surfaces clean and dark. The surface of each roller must be kept seriously clean. Always clean the machine immediately after applying the machine. Wash with glue thinner (alcohol or xylene) and wipe each roller with a soft towel. It is strictly prohibited to scrape the surface of the roller with a sharp tool. Every time the machine is turned on, the dust on the surface of each roller should be wiped off. The automatic laminating machine checks whether the surface of each roller is dark, if the machine is faulty or abnormally sound, it should analyze and find the cause in time and remove it. After the standby device is normal, the machine can continue to be used;
         3. The grounding of the automatic laminator machine and the insulation of electrical appliances should be ensured;
         4. The blade line of the scraper blade of the automatic laminating machine should be kept flat and elastic. When there are detours, teeth, curling, etc., it should be repaired and replaced in time. The application of 0.15~0.20 mm manganese steel skin or offset printing machine Replace the blade according to the original specifications;
        5. Fully automatic laminating machine should regularly add lubricating oil to the transmission parts and sliding surfaces of the machine to ensure that the machine is in a good lubrication state. In particular, due to the high pressure and high temperature encountered by the large bearing of the pressure roller, the lubricating oil is volatilized and lost. The dwarf high-temperature lubricating oil should be timely so that it can normally perform duties under high temperature and high pressure

        6. A comprehensive inspection of the machine should be carried out once a year to find the problem and solve it in time to avoid more serious damage to the machine.