In the process of using the automatic laminating machine, there will be some small problems. These problems may be caused by our inadvertent use during the ordinary use process. There are also some reasons because of the length of time that a full-automatic laminating machine is used. As a result, the automatic laminating machine manufacturers conducted an investigation on this, and found that the common problems when using the automatic laminating machine are nothing more than three types: electrical circuit, rubber circuit, and gas circuit.
        1. Circuit problem, if it is rubber birch or automatic laminating machine, the hose is not heated. Let's first check whether the fuse is burned out, whether there is any problem with the fusion, and check the temperature controller and the solid state relay or IC. If there is no problem with the above, then there is a problem with the circuit. You should check the circuit.
        2. The problem of the plastic line. When the temperature of the hose glue gun is normal, it is the glue road problem that the glue does not come out. First check which part does not come out. The glue is the problem of the glue gun. The glue gun should be cleaned. If there is no glue out of the hose, there may be a problem with the host. There are three reasons why the host does not give out glue. One is that the inverter is broken (sent for inspection or replacement); the other is that the motor has problems (same as handling the inverter); There is a problem with the pump (check whether the seal or the pump is broken).
       3. The problem of the air circuit, in the process of using the automatic laminating machine, the solenoid valve is generally used for control. This causes a problem in the gas circuit. If there is a problem in the gas circuit, first check whether the gas is reversed or whether the solenoid valve is It is broken, or the wrong type of solenoid valve is used.