Fully automatic laminating machine vacuum laminating is to use a special vacuum laminating machine to evacuate the film and the painting and set it at a certain temperature to complete the laminating. The operation method is complicated, the cost is high and the picture size is limited, but the mounting quality is very high and the picture texture is strong, which is suitable for photos.
Trouble shooting one of the automatic laminating machine: the machine does not start
The input wire is disconnected, the power cord is reversed, and the voltage is insufficient.
Trouble shooting of automatic laminating machine 2: temperature measurement is not accurate
Thermocouple, temperature controller. Whether the installation is incorrect and damaged.
Trouble shooting three for automatic laminating machine: working vacuum cannot come up
The air path is blocked, the hand valve or solenoid valve is not closed, the vacuum pump motor belt is loose, and the vacuum gauge is damaged.
Trouble shooting of automatic laminating machine 4. The main power switch trips
The leakage of the input wires on the top of the heating box, the leakage of the distribution box, the external wires are laid on the equipment, and the leakage of the motor.
Troubleshooting 5 of automatic laminating machine: the film is not in place
The vacuum is not enough, air leakage, temperature is not enough, the film is too thin, the workpiece is pasted with other materials, the depth of the workpiece exceeds the pull-up of the film, the suction time is too short, the film is not lifted, and the workpiece is too close.
Troubleshooting 6 of automatic laminating machine: the surface of the coated workpiece is folded and not smooth or the corners cannot be wrapped
The film is not straightened, the film quality is not good, the workpiece is not polished well, too much glue is sprayed, and the mold below the workpiece is too low.
Trouble shooting 7 of automatic laminating machine: the film is pulled down when the suction is not reached
Whether the solenoid valve or hand valve is open.
Trouble shooting for automatic laminating machine 8: break phenomenon

The temperature is too high, the heating time is too long, the film quality is not good, and there is no heating.