Self-adhesive film laminating machine manufacturers introduced that we often see self-adhesive products in life, so what kind of adhesive is used for self-adhesive? In fact, the glue used for stickers is the adhesive.
        Adhesive refers to an adhesive that is sensitive to pressure and only needs to use contact pressure to glue two different materials together. Apply the adhesive to thin flexible substrates such as paper base, cloth base or plastic to make adhesive products such as labels, tapes and films. Mainly used for packaging, office, vehicles, building finishing, protection, metal, plastic, etc.
        The self-adhesive film laminating machine manufacturer stated that the pressure-sensitive adhesive tape is the most convenient to use, and therefore has developed the fastest. The pressure-sensitive adhesive tape is composed of pressure-sensitive adhesive, primer, base material, back-side treatment agent and release paper. What kind of glue is used for stickers? Pressure-sensitive adhesive is the most important part of the adhesive. It must have good adhesion between the adhesive tape and the adherend under external pressure.
        The pressure-sensitive adhesive base material used for adhesives of adhesive laminating machine manufacturers is the basis for supporting pressure-sensitive adhesives. It requires good mechanical strength and small elasticity. It has good wettability to solvents, etc. Fabric, paper tape and plastic film.
        What are the safe operation procedures and precautions for the operation of the adhesive laminator?
        The self-adhesive film laminating machine is a mechanical device that divides a wide PVC film into multiple narrow materials. When operating the slitting machine, you should pay attention to the safe operation process:
        1. Turn on
       1. Turn on the electrical isolation switch (set in front of the electrical control cabinet), press the EMERCENCY STOP RESET and READY TO RUN buttons, the key opens the MACHINE to RUN (on the main operating platform) to check whether the voltage and current are correct and stable.
        2. Turn on the power switch of the hydraulic system (set on the main hydraulic drive frame) to check whether the oil level and pressure gauge of the main hydraulic drive system are correct and stable.
        3. Open the pneumatic shut-off valve (set on the air intake pipe under the pneumatic control cabinet) to check whether the air pressure is correct (not less than 6.0bar) and stable.
         2. Setting control
         1. Set the cutting menu according to the type, thickness, length, width, etc. of the PVC film arranged in the cutting plan.
        2. Lift the corresponding PVC film file from the PDF.
        3. Set the winding length and width of the film with corresponding specifications.
        4. Select the corresponding winding station, adjust the roller arm and roller, and install the paper core of corresponding specifications.
        3. Feeding, film passing and film joining
        1. Feeding: According to the requirements of the cutting plan, according to the driving operation regulations, according to the actual situation, hang the corresponding parent roll on the aging frame, choose the direction according to the inside and outside of the corona surface, and place it on the cutting machine unwinding frame, and use The control button clamps the steel core, leaving the steel core support arm and driving.
        2. Film penetration: When there is no film on the slitter, film penetration is required. Use the slitting device and function keys of the slitting machine to tie one end of the original film to the eye of the film linking chain, and activate the filming button so that the film is evenly distributed on each roller along the slitting process.

        3. Membrane connection: When there is membrane on the slitting machine, when changing the roll joint, use the vacuum membrane table to start the membrane connection table to the working position, manually flatten the film on the first traction roller of the slitter and start the upper vacuum pump Suction the film to make the film flat to be adsorbed on the film receiving table, attach double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding rack and start the lower vacuum pump to make the film flat to adsorb, remove the tape Put on the paper layer and level the adhesive film. The joints should be neat and wrinkle-free. Then turn off the upper and lower vacuum pumps, and open the film receiving table to the inoperative position.