The automatic laminating machine is best to regularly check whether there is glue or grease on the rubber roller, and wipe the rubber traces and dust on the roller in time. Ensure that the appearance of the two rolls is washed black. The surface of each roller must be cleaned. Not only is it necessary to clean the machine immediately after using the machine each time. Wash with glue thinner and wipe the rollers with a soft towel. It is strictly forbidden to scrape the surface of the drum with a sharp tool. Every time the machine is turned on, the surface dust of each roller should be wiped off. Computer bronzing machine and check whether the appearance of each roller of the machine is black, when the machine shows defects or abnormal dynamics, it is necessary to analyze and find the reason and eradicate it in time, and wait until the machine is normal before allowing it to continue to operate.

        The blade line of the scraper blade of the automatic laminating machine should be flat and elastic. When the appearance of detours, teeth, curling, etc. should be modified and replaced in time, use 0.15~0.20 mm manganese steel skin or the blade of the offset printing machine. Exchange it according to the original standard. Lubricant should be added to the transmission parts and sliding surfaces of the machine on time to ensure that the machine is in excellent lubrication conditions. Especially the large bearings of the pressure rollers are subject to high pressure and high temperature, and the lubricant is evaporated and thrown away at will. High temperature lubricating oil, so that it can operate normally under high temperature and high pressure. The floor formwork support of the automatic laminating machine uses the steel pipe bracket composed of the connection piece and the steel pipe, and gradually opens up perfectly as a fastener type steel pipe bracket.