Now the laminating machine is already a necessary equipment in the advertising industry, and everyone must know its major utility. The film is divided into cold film and hot film. The cold film itself is sticky and can be directly bonded to the material; while the hot film itself is not sticky and needs to be melted by heating to bond to the material. The manual cold laminator is very suitable for the small advertising companies with small business volume, which can not only realize lamination, but also save costs. Small investment can achieve big benefits. Jintu wide-width multi-functional cold laminating film machine has three different sizes to choose from, the width of the film is 1600mm, 1300mm and 1100mm, to meet your different size needs. The maximum film thickness reaches 25mm, which is superior to other machines in the industry.
        Analysis of the causes of wrinkling of laminating film on graphic laminating machine and key points of laminating machine operation
        1. Analysis of the causes of wrinkling of mounting film
        (1) The raw material has a high degree of tightness on one side or a loose middle between the two sides, causing unevenness of the paper surface and causing wrinkling of the mounting film.
        (2) The poor temperature resistance of the raw materials causes deformation after entering the oven and causes the mounting film to wrinkle.
        (3) The quality of the laminating machine is different, and the laminating film with a poor laminating machine causes the laminating film to wrinkle.
        (4) The laminating staff's poor operation skills or improper operation directly cause the laminating film to wrinkle.
         2. Key points of operation of laminating machine
        (1) Install the laminating machine on a special bracket and place it on a stable and firm workbench. Then make a special platform for laminating film, the height is 5 mm lower than the edge height of the laminating machine, the width is 1600 mm, and the length is more than 1 meter.
        (2) Place the material to be mounted on the laminating machine or the empty laminating machine on the iron roller in front of the laminating machine. After entering the laminating machine, the coating surface should face upward.
        (3) Adjust the pressure adjusting hand wheel on the laminating machine, lift the upper rubber roller, and then pass the material out of the two rubber rollers of the laminating machine by 10 cm.
        (4) If laminating film is needed, the cold laminating film needs to pass through 10 cm of the two rubber rollers of the laminating machine and be placed on top of the consumables. The PVC film is super-oriented.
        (5) Adjust the position of the consumables on the platform so that the tightness of the two ends of the laminating machine is basically the same, and then adjust the pressure hand wheel on the laminating machine, lower the top roller and adjust it to the empty position. The pressure on both ends must be the same.
        (6) If it is an empty film laminating machine, you can shake the hand wheel to move the consumables forward. When shaking, it must be uniform, and the moving speed should be the same, not when it is fast or slow. If there is no wrinkle after 5 meters, it means there is no quality problem of consumables.
        (7) If laminating film is required, first fold the cold laminating film release paper inwards to expose the glue surface on the PVC film, then shake the handwheel in the opposite direction, first stick the adhesive surface to the consumables, and then cold laminating Turn the film over to the back of the rubber roller, and slowly release the cold laminating film from the folded place. At this time, turn the rubber roller to rotate it forward, and slowly remove the release paper as the rubber roller rotates, and maintain the tightness of both sides Consistent and certain intensity until the end of cold mounting.

        (8) If the consumables are deviated during empty running or laminating, it indicates that there is a problem with the operation and it has nothing to do with the consumables.