The operation of the laminating machine and its safe operating procedures are very important to us, because it is related to the correct and safe operation of the machine and equipment, so it is necessary to carry out relevant understanding in order to do the homework in advance. To achieve the above purpose. So below, the editor will give a good introduction to this knowledge, so that everyone can understand and learn more clearly.
        1. Detection before startup
        (1) Whether the machine equipment is in a safe state, adjust the film transportation to make the film tension even.
        (2) Check the gap between the glue roller and the glue, and the temperature of the heating roller, whether it is normal, if any problems should be dealt with in time.
        (3) Check whether the pressure meets the specified requirements, clean the rubber roller, and remove debris.
        2. Processing at the end
        (1) After the work is completed, stop heating first, and wait until the temperature drops, then stop the motor and fan.
        (2) Clean the roller and rubber roller, add lubricating oil to lubricate the machine, and finally cut off the power of the machine.
        3. Safe operating procedures
        (1) There should be no flammable and explosive materials near the machine to avoid fire.
        (2) When the machine is running, the operator is strictly prohibited from making dangerous actions to avoid danger or accidents.
         (3) If the temperature of the roller is too high, do not touch it directly with your hands to avoid being burned.
         (4) The scrubbing of the machine should be carried out correctly, and it can only be turned on at a low speed.
         (5) When the machine is stopped, the hydraulic system should be unloaded, and the pressure roller and rubber roller should be separated.
        (6) The maintenance of the machine should be carried out in the state of power off.
        (7) Do not place any objects or even debris on the machine.