In the processing file of the laminating machine, the requirements for each part of the machine are very high, such as the accuracy of the surface of the rubber roller. If the rubber roller has some marks, scratches, deformation, etc., the processed files will affect the processing effect. For example, after processing, it is blurry and unclear; such processed files also need to be reworked, which will be very troublesome. It can be seen from this that the precision of the machine is inseparable from the maintenance after using the laminator, and regular inspection and maintenance. So, what should be done for daily maintenance?
        Always check the oil pipes, valves and cylinder plugs of the hydraulic system for oil leakage. When oil leakage is found, replace the sealing ring in time and fill the hydraulic cylinder with an appropriate amount of hydraulic oil.
        The blade line of the scraper blade should be kept flat and flexible. When there are detours, teeth, curling, etc., it should be repaired and replaced in time. Use 0.15 ~ 0.20 mm manganese steel skin or the blade of the offset press, and replace it according to the original size Of it.
        Lubricating oil must be added to the transmission parts and sliding surfaces of the machine regularly to ensure that the machine is in a good lubrication state. In particular, due to the high pressure and high temperature encountered by the large bearing of the pressure roller, the lubricating oil is volatilized and lost. The dwarf high-temperature lubricating oil should be timely so that it can normally perform its duties under high temperature and high pressure.
        Check whether there is rubber or grease on the rubber roller, and wipe off the glue and dust on the roller in time. Keep the two rolled surfaces clean and dark. The surface of each roller must be kept seriously clean. Always clean the machine immediately after applying the machine. Wash with glue thinner (alcohol or xylene) and wipe each roller with a soft towel. It is strictly forbidden to scrape the surface of the roller with a sharp tool. Every time the machine is turned on, the dust on the surface of each roller should be wiped off. And check whether the surface of each roller of the machine is dark, the machine is malfunctioning or abnormal sound, should analyze and find the reason in time and remove it. After the standby device is normal, you can continue to use the machine.

        The above are the points that should be done when doing maintenance for the laminating machine; in addition, when you find that the machine has a problem, you should contact the relevant professionals for repair in time; early detection and early treatment can save you A lot of unnecessary trouble.