The hot laminating machine instant coating laminating machine includes three parts: gluing, drying and hot pressing. It is a pre-coating laminating machine widely used in China at present. There is no gluing and drying parts. It has small size, low cost and flexible operation. Convenient, not only suitable for laminating processing of large quantities of printed products, but also suitable for laminating processing of small batches and scattered printed products such as automated desktop office systems, which has a promising future.
        The laminating process is a surface processing process after printing. It is also known as post-press lamination, post-press laminating or post-press laminating. It refers to the use of a laminating machine to cover a layer of 0.012 ～ 0.020mm on the surface of the printed product. The thick transparent plastic film forms a paper-plastic integration product processing technology. The laminating machine is the equipment used to complete the laminating process. Generally speaking, it can be divided into two types: instant coating film and pre-coating film according to the process used, and two kinds of bright film and matte film according to the different film materials.
        This type of thermal laminating machine is widely used in photo agencies, printing plants, advertising, design and adhesives. It has less investment and obvious effects. The consumables used are non-polluting. They are green and environmentally friendly products and have great market potential.
        Operation process steps of hot laminating machine:
        The first step is to use a bracket to stabilize the thermal laminator and fix it firmly on the workbench. To make a special platform for laminating, this step is actually to fix the machine and arrange the platform for laminating. This is the beginning and the key step. Whether the product has a good laminating effect is the key.
        The second step is to fix the material needed for the film on the iron roller, and the film coating is facing upward, adjust the pressure of the rubber roller, slowly adjust it, and remove the material that needs to be coated from the middle of the rubber roller and the machine. Just wear out more than 10 centimeters.
        The third step is to tighten the product and adjust the position, which is a good display of the effect of the film when the product is used, and has become a key point of elaborate production. In addition, in the early operation, we must pay attention to the effect of fixing the product to avoid skew.
        The fourth step, if you need to mount the film, you need to pass the cold laminating film out of the two rubber rollers of the laminating machine, 10 cm, and place it on top of the consumables. position. The pressure on both ends must be the same.
        The fifth step, when there is a slanting phenomenon in the process of use, it means that you have not placed it properly, and it should be carried out after being placed. You can go for a short time, cut it off slowly, re-center it, and start the machine to work. (Remind everyone, you must be even and stable when you are correcting, take your time)
        The sixth step, if there are wrinkles, don't stop the machine immediately, let him continue to run for a while, then stop the machine, and slowly take out or cut the film, if you are using a cold laminator, it may be There will be excessive pressure, because the machine itself has not completely stopped, and the problem can be solved after the machine stops.

       The above is a detailed explanation of the steps of the operation process of the hot laminating machine. If you have any questions, please call our factory for consultation. There will be professional technical staff to teach you how to do it.