The blade adjustment starts from the installation. First, confirm that the machine is in a stopped state and cut off the power. Place the sharpened paper cutting machine blade on the tool changer, push the tool changer to the front knife bed of the paper press, adjust Cut the selector switch to the tool change position and turn the knife hanging device, raise the blade and tighten the connecting screw, then loosen and remove the tool changer, tighten the remaining fastening bolts, and the tool change is completed.

        The adjustment of the paper cutting machine blade is to adjust the cutting amount of the blade to avoid cutting the blade too deeply and damaging the blade due to the height of the newly replaced blade. The blade adjustment steps are: first manually rotate the transmission wheel to determine the blade cutting depth, the knife bed moves to At the lowest point, carefully observe whether the cutting depth is reasonable. Under normal circumstances, the normal cutting is 0.5-1 mm; if the blade edge is in contact with only one end of the blade, you can adjust the eccentric shaft behind the main frame; if the regrinded blade cannot cut the paper The blade can be moved down until the paper can be completely cut, and the top knife cam can be manually rotated to make the blade cut the paper; the adjusted blade can be used for trial cutting with waste products, and then the normal work is performed after the sample is normal.