If the cutter blade is not sharp, you need to replace the blade. Today I will introduce how to replace the cutter blade.
        1. Place the blade of the toilet paper cutter at the uppermost position, turn off the machine running switch, cut off the power, and stop the machine. When the machine is stopped, the machine needs to be placed in the cranking state, and the tool bed is stopped in the middle position during cranking. Before replacing the blade, you need to loosen all the screws that fasten the blade on the knife bed, and then insert the tool of the knife into the hexagonal hole on the knife bed, and rotate it counterclockwise, the blade can automatically fall. Put the screw of the knife handle of the tool into the screw hole of the blade, hold the knife handle with your hand, you can take the blade off the hook and put it on the attachment rack, put it in the box to send the grinding.
        2. After removing the blade of the toilet paper cutter, you need to check, check the angle and width of the blade sharpening, wipe the blade with a soft cloth from the back to the blade, then screw the knife wrench into the grinding Or insert the screw hole of the replaced blade into the attachment and push it to the vicinity of the knife bed. The blade is lifted so that the two holes in the middle groove of the blade are hung on the hook extending from the knife bed. Remove the knife handle and install the knife Insert the wrench into the hexagonal hole of the cutter bed and turn it clockwise to automatically raise the blade to a fixed position. Tighten all bolts that secure the blade on the tool bed. The entire process of inserting the blade requires extra care to avoid any hard objects on the blade. Finally, put away all kinds of tools, and the blade fixing work is completed.

        The above is the specific content introduced to you by the editor. The papermaking machine is originally a consumable. Long-term use will cause the loss of machine parts. Therefore, the daily maintenance of the machine is the key to improving the service life of the machine.