The use of the paper cutter must be carried out according to the regulations. What should I do? Let's take a look together with paper cutter manufacturers!
        1. The safety ground wire must be connected.
        2. The two-handed linkage button. When cutting paper, you need to keep pressing the lower knife switch with both hands. You cannot release it until the blade stops moving. When the paper presser returns to the highest position, you can release the two-hand switch. The starting point of this design is to protect the safety of the operator, in line with the people-oriented design concept.
        3. The paper-pushing system is a slotless double guide rail, and it is not easy to tilt and shift from left to right, but also pay attention to not adding a large impact force to the paper pusher.
        4. The paper cutting drive system of the paper cutter is electromagnetic clutch, gear reduction transmission, usually pay attention to keep the gear box clean, if there is paper debris, it should be cleaned in time.
        5. The electromagnetic clutch is powered by carbon brushes, and the cutter should check the wear and power transmission of the carbon brush before going to work.
         6. Pay attention to the lubricating of the paper screw, and if possible, check the clearance of the screw nut every quarter.
        7. The back lever of the knife has been strengthened. For the upper part of the bar bushing, oil-free bearings are used (copper-based inlaid composite bearings, which can be heavily loaded without oil. Copper is centrifugally cast and has a hardness of hb245. Bite!) Maintenance is simple, as long as you occasionally add lubricating oil from the pin shaft of the knife back (nozzle is at the back), the pull-down rod uses powder metallurgy bushing, plus a drip-type oil cup, long service life and large bearing capacity.
        8. The hydraulic system is designed and produced with reference to the German Bora knife system, and the system works stably. Because of the bad working environment, the valves of the hydraulic system of the machine are occasionally blocked, causing the paper presser not to press down. Don't panic if the paper presser does not press down. Remove the valve and clean it according to the instructions.
         9. The clutch clearance also needs frequent attention. The surface of the brake pads must not be oily. If there is oily contamination, the source of the oily contamination should be considered. If there is too much oil stored at the front gear, stop the refueling and clean the oil sump.
        10 When the operator releases the lower knife switch at any time, the blade will stop immediately. We require the operator to strictly abide by the operating rules to operate the machine.
        11. Regularly check the integrity and reliability of the encoder and the forward and backward switches. The hydraulic system is relatively sensitive to hydraulic oil, please add lubricating oil according to the instructions. Generally, No. 68 is used in summer, and No. 46 wear-resistant hydraulic oil is used in winter. When replacing hydraulic oil, pay attention to clean the oil pool.

        After reading the above, you now know how to use the paper cutter!