The high-speed slitting machine needs certain inspections before starting, during the production process, or after making the product.
        1. Start up slowly, observe whether the slitting film meets the quality requirements, and then slowly accelerate to start slitting. When the machine is running, it is strictly forbidden to put your hand into the machine to avoid the back of the hand from being pressed.
        2. Open (close) the raw material bracket to a suitable width, and place the semi-finished film roll to be cut on the bracket. When loading, the hand must leave the film roll section. Two people are not allowed to operate at the same time to prevent hand Clamped by the cylinder.
        3. Check whether the number of joints on the cross-section of the product is the same as the number of the self-connected one. If the hot-melt adhesive coating machine does not match, immediately rewind the check to prevent the internal joints from being mixed into the product.
        4. Stop pressing the stop button. When unwinding, do not allow your hands to touch the rewinding shaft to prevent your fingers from being caught.
        5. According to the characteristics of the semi-finished product, adjust the EPC device to ensure that the EPC photoelectricity is always on the tracking line, and use the hand to pull the end of the film at a low speed to start the film and make the film go into normal.
        6. Return the photoelectricity to the center position to ensure that the slider of the unwinding table is kept in the proper position in the middle of the guide bar.

        7. Put the paper tube that meets the specifications on the take-up shaft, cut the products that meet the requirements into the paper tubes of the upper and lower take-up shafts drawn according to the normal method, start at a low speed, and find out that the paper tube is suitable on the take-up shaft Mark the location of the installation to facilitate the next installation. When installing the paper tube, the hand must grasp the surface of the paper tube to prevent it from falling and being injured by the shaft.